readme.md (1586B)
1 # CHORD ZERO Stenographic Keyboard 2 3  4 5 CHORD ZERO is a stenographic keyboard that can be used with 6 [Plover](https://www.openstenoproject.org/plover/) or any other application 7 that supports the [TX 8 Bolt](https://docs.qmk.fm/#/feature_stenography?id=tx-bolt) or 9 [GeminiPR](https://docs.qmk.fm/#/feature_stenography?id=geminipr) protocol. 10 11 * Keyboard Maintainer: [Simon Hengel](https://github.com/sol) 12 * Hardware Supported: REV 0, REV 1 13 * Hardware Availability: https://github.com/sol/chord-zero#readme 14 15 Make example for this keyboard (after setting up your build environment): 16 17 make chord/zero:default 18 19 or 20 21 qmk compile -kb chord/zero -km default 22 23 This will generate `chord_zero_default.uf2`. 24 25 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). 26 27 ## Bootloader 28 29 Enter the bootloader in 3 ways: 30 31 * **Reset key combo**: Press the six keys at the outer columns on each side of the keyboard simultaneously while it is plugged in 32 * **Bootmagic reset**: Hold down the top left key and plug in the keyboard 33 * **Physical reset button**: Press the button on the back of the PCB and plug in the keyboard 34 35 Once the keyboard is in bootloader mode you can mount it as a USB mass storage 36 device and copy the firmware (the file `chord_zero_default.uf2`) onto it. Once 37 copying is completed the keyboard will reboot automatically.