qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1210B)

      1 # Flame60
      2 
      3 ![Flame60 PCB](https://i.imgur.com/vdOxw3j.jpeg)
      4 
      5 The Flame60 consists of a screwless exterior, flex cut pcb and plate to ensure a soft typing experience.
      6 
      7 * Keyboard Maintainer: [CMM.Studio Freather](https://github.com/frankBTHID)
      8 * Hardware Supported: Atmega32u4
      9 * Hardware Availability: [CLAP.STUDIO (Instagram)](https://www.instagram.com/clap__studio__/)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make clap_studio/flame60:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make clap_studio/flame60:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     27 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available