qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1103B)

      1 # SBL
      2 
      3 ![SBL](https://i.imgur.com/HqRfr4bh.jpg)
      4 
      5 An O ring mount 60%, akin to the otd 356mini
      6 
      7 * Keyboard Maintainer: [Zeix](https://github.com/itsme-zeix)
      8 * Hardware Supported: SBL Solder PCB rev1
      9 * Hardware Availability: https://dnworks.co/products/sbl
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make dnworks/sbl:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make dnworks/sbl:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Physical reset button**: Short the 'USB_BOOT' button and plug in keyboard or briefly short the `RESET` and `GND` pads on the SWD header twice
     27 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available