qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1812B)

      1 # EnvKB DELIRIUM
      2 
      3 ![Image of EnvKB TKL PCB](https://i.imgur.com/a7UaS4mh.png)
      4 
      5 A low cost standard TKL design which takes inspiration from the CFTKB Mysterium. All versions are designed for reference Pi Picos.
      6 
      7 * Keyboard Maintainer: [Envious-Data](https://github.com/envious-data)
      8 * Hardware Supported: 
      9   * Delirium Prototype (`tkl/rev0`)
     10   * Delirium (`tkl/rev1`)
     11   * Delirium RGB (`tkl/rgb`)
     12 * Hardware Availability: [Mechboards](https://mechboards.co.uk/products/envkb-delirium-tkl-kit), [GitHub](https://github.com/Envious-Data/Env-KB)
     13 
     14 Make example for this keyboard (after setting up your build environment):
     15 
     16     make enviousdesign/tkl/rgb:default
     17 
     18 Flashing example for this keyboard:
     19 
     20     make enviousdesign/tkl/rgb:default:flash
     21 
     22 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     23 
     24 ## Bootloader
     25 
     26 Enter the bootloader in 3 ways:
     27 
     28 * **Bootmagic reset**: Hold down the top left key and plug in the keyboard. This will also clear the emulated EEPROM, so it is a good first step if the keyboard is misbehaving.
     29 * **Physical reset**: Hold down the `BOOTSEL` button on the Pi Pico, then either plug the board in or press the `RESET` button.
     30 * **Keycode in layout**: Press the key mapped to `QK_BOOT`. In the pre-supplied keymaps it is on the second layer, replacing the Esc key.
     31 
     32 After entering the bootloader through one of the three methods above, the keyboard will appear as a USB mass storage device named `RPI-RP2`. If the CLI is unable to find this device, the compiled `.uf2` file can be manually copied to it. The keyboard will reboot on completion with the new firmware loaded.