qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (2315B)

      1 # 3dfoxc
      2 
      3 ![3dfoxc](https://cdn.thingiverse.com/assets/12/3a/3e/5f/47/64A223C2-57E8-4124-B6AB-3031A0BA7973.jpeg)
      4 
      5 A [3d-printed whitefox](https://www.thingiverse.com/thing:2952008) with an Elite-C microcontroller.
      6 
      7 This is a build of [matt3o's "How to Build a Custom Keyboard" guide](https://matt3o.com/book/), except that I have replaced the Teensy with an [Elite-C v4](https://keeb.io/products/elite-c-low-profile-version-usb-c-pro-micro-replacement-atmega32u4). Presumably you could replace it with anything compatible.  The USB-C port had to be enlarged with dremel, and the mount for the Teensy was ground off and replaced with everyone's favorite rapid modeling polymer ... hot glue.
      8 
      9 * Keyboard Maintainer: [david l goodrich](mailto:dlg@dsrw.org)
     10 * Hardware Supported: 
     11    * [3d-printed whitefox](https://www.thingiverse.com/thing:2952008)
     12    * Elite-C microcontroller 
     13 * Hardware Availability: [keebio](https://keeb.io/products/elite-c-low-profile-version-usb-c-pro-micro-replacement-atmega32u4), [1up](https://1upkeyboards.com/shop/controllers/elite-c-v4-controller/), [keyhive](https://keyhive.xyz/shop/elite-c), [splitkb](https://splitkb.com/products/elite-c-low-profile-rev4-microcontroller)
     14 
     15 ## Wiring
     16 
     17 Badly, because I have never done this before. Build pics available upon request, I guess.
     18 
     19 ![wiring diagram](https://user-images.githubusercontent.com/6492494/148123622-36cae91e-97f3-40f7-a6fc-4d59b1a3ef02.png)
     20 
     21 
     22 ## Flashing
     23 
     24 Make example for this keyboard (after setting up your build environment):
     25 
     26     make handwired/3dfoxc:default
     27 
     28 Flashing example for this keyboard (use the `dfu` target for the Elite-C!):
     29 
     30     make handwired/3dfoxc:default:dfu
     31 
     32 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     33 
     34 ## Bootloader
     35 
     36 Enter the bootloader in 3 ways:
     37 
     38 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     39 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     40 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available
     41 
     42