qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1414B)

      1 # 3dortho14u
      2 
      3 ![3dortho14u](https://i.imgur.com/us16LYTh.jpg)
      4 
      5 A symmetrical 14u wide ortholinear keyboard.
      6 
      7 In addition to the 3d printed parts and microcontroller, the following hardware is required:
      8 * 8 * 12 mm M3 bolt
      9 * Either:
     10   * 8 * M3 muts and CA glue
     11     OR
     12   * 8 * 3x3 mm threaded insert
     13 * Optional:
     14   * USB daughter board
     15 
     16 ---
     17 
     18 * Keyboard Maintainer: [xia0](https://github.com/xia0)
     19 * Hardware Supported:
     20   * rev1: Teensy 2.0 (ATmega32u4)
     21   * rev2: Arduino Pro Micro (ATmega32u4)
     22 * Hardware Availability: [github](https://github.com/xia0/keeb_files/tree/main/3dortho14u)
     23 
     24 Make example for this keyboard (after setting up your build environment):
     25 
     26     make 3dortho14u/rev1:default
     27 
     28 Flashing example for this keyboard:
     29 
     30     make 3dortho14u/rev1:default:flash
     31 
     32 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     33 
     34 ## Bootloader
     35 
     36 Enter the bootloader in 3 ways:
     37 
     38 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     39 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     40 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available