qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1209B)

      1 # alcor_dactyl
      2 
      3 ![alcor_dactyl](https://i.imgur.com/F0E1JCQh.jpg)
      4 
      5 This is a handwired dactyl manufor utalising an RP2040-zero
      6 
      7 * Keyboard Maintainer: [Ethan](https://github.com/rocketstrong)
      8 * Hardware Supported: Waveshare RP2040-Zero
      9 * Hardware Availability: https://www.waveshare.com/wiki/RP2040-Zero
     10 * 3D Print File Source: https://dactyl.mbugert.de/manuform
     11 
     12 Make example for this keyboard (after setting up your build environment):
     13 
     14     make handwired/alcor_dactyl:default
     15 
     16 Flashing example for this keyboard:
     17 
     18     make handwired/alcor_dactyl:default:flash
     19 
     20 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     21 
     22 ## Bootloader
     23 
     24 Enter the bootloader in 3 ways:
     25 
     26 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     27 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     28 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available