readme.md (1498B)
1 # dactyl_manuform_pi_pico 2 3  4 5 This is a dactyl_manuform 5x6 running Rasrberry Pi Pico. 6 It's based on alcor_dactyl but with more reasonable GPIO layout for Pi Pico 7 and clasic dactyl_manuform layout (pinkies have only 4 rows). 8 9 Build instructions: https://github.com/GustawXYZ/dactyl_manuform_pi_pico/ 10 11 * Keyboard Maintainer: [Gustaw.xyz](https://github.com/Gustaw.xyz) 12 * Hardware Supported: Raspberry Pi Pico and other RP2040 13 * Hardware Availability: https://www.raspberrypi.com/products/raspberry-pi-pico/ 14 * 3D Print model: https://github.com/abstracthat/dactyl-manuform 15 16 Make example for this keyboard (after setting up your build environment): 17 18 make handwired/dactyl_manuform_pi_pico:default 19 20 Flashing example for this keyboard: 21 22 make handwired/dactyl_manuform_pi_pico:default:flash 23 24 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). 25 26 ## Bootloader 27 28 Enter the bootloader in 3 ways: 29 30 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard 31 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead 32 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available