qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1362B)

      1 # snatchpad
      2 
      3 ![snatchpad etch-a-sketch macropad](https://i.imgur.com/aRIM8Nah.jpg)
      4 
      5 A 6-key macropad with 2 rotary encoders intended for use as a pointing device.
      6 
      7 In addition to the 3d printed parts and microcontroller, the following hardware is required:
      8 * 4 * 3x3 mm threaded inserts
      9 * 4 * 4mm M3 bolt
     10 * USB daughter board
     11 
     12 ---
     13 
     14 * Keyboard Maintainer: [xia0](https://github.com/xia0)
     15 * Hardware Supported: e.g. Arduino Pro Micro
     16 * Hardware Availability: [github](https://github.com/xia0/keeb_files/tree/main/snatchpad)
     17 
     18 Make example for this keyboard (after setting up your build environment):
     19 
     20     make handwired/snatchpad:default
     21 
     22 Flashing example for this keyboard:
     23 
     24     make handwired/snatchpad:default:flash
     25 
     26 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     27 
     28 ## Bootloader
     29 
     30 Enter the bootloader in 3 ways:
     31 
     32 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     33 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     34 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available