readme.md (2130B)
1 # Drashna's Blackpill Tractyl Manuform (5x6) with a right side trackball 2 3 * System Timer on TIM5 4 * VBUS mod, using PB10 -- does work, but not on my tractyl... bad soldering probably 5 * Split Hand Pin, using PC14 6 * Full Duplex Serial/USART using PA2 and PA3 on USART2 7 * PWM Audio using PB1 and TIM3 and GPT on TIM4 8 * PWM WS2812 RGB using PA1 TIM2 9 * 8KB SPI EEPROM chip sharing PA5-PA7 on SPI1 with PA4 as CS pin 10 * pmw3360 sensor sharing PA5-PA7 on SPI1, with B0 as CS pin 11 * Encoder using PA13 and PA14 12 * SSD1306 OLED display (128x64) using PB8-PB9 on I2C1 13 * Pull-up resistor (22k) on PA10 to fix reset issue. 14 * Pull-up resistor (5.1k) on PA1 for WS2812 LED support, and wire it's VCC to the 5V pin. 15 * Pins PA9 is meant for VBUS sense, and has an internal pulldown resistor. A 5.1k pullup resistor can work (but should be avoided) 16 * Pins PA11 and A12 are not useable because they're used for USB connection, and can't be shared. 17 * Pin PB2 is used by BOOT1, and is unusable 18 19 ## Keyboard Info 20 21 * Keyboard Maintainer: [Drashna Jael're](https://github.com/drashna) 22 * Hardware Supported: [Design files](https://gitlab.com/keyboards1/dm_r_track/-/tree/master/boolean), [WeAct BlackPill (F411)](https://github.com/WeActStudio/WeActStudio.MiniSTM32F4x1), [PMW3360 Optical Sensor](https://www.tindie.com/products/jkicklighter/pmw3360-motion-sensor/) 23 24 Make example for this keyboard (after setting up your build environment): 25 26 make handwired/tractyl_manuform/5x6_right/f411:default 27 28 Flashing example for this keyboard: 29 30 make handwired/tractyl_manuform/5x6_right/f411:default:flash 31 32 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). 33 34 ## Bootloader 35 36 * **Bootmagic reset**: Hold down the top right key on the right side, or the top left key on the left side while plugging in. 37 * **Physical reset button**: Briefly press the "USER" button on the BlackPill 38 * **Keycode in layout**: Press the key mapped to `QK_BOOT`.