qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (958B)

      1 # Wakizashi 40
      2 
      3 ![Wakizashi40](https://i.imgur.com/TVTfa0X.jpg)
      4 
      5 Reverse stagger 40% keyboard based on the Katana 60.
      6 
      7 * Keyboard Maintainer: [xia0](https://github.com/xia0)
      8 * Hardware Supported: ATmega32u4
      9 * Hardware Availability: [prusaprinters.org](https://www.prusaprinters.org/prints/128575-wakizashi-40-keyboard)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make handwired/wakizashi40:default
     14 
     15 See [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) then the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information.
     16 
     17 ## Bootloader
     18 
     19 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     20 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     21 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available