qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1163B)

      1 # Yoda Distro
      2 
      3 ![YodaDistro](https://i.imgur.com/W2xnKjF.jpeg)
      4 
      5 Scratch made direct wire pin 8-Key (4x2) Macro Pad using a Raspberry Pi Pico (2040).
      6 
      7 * Keyboard Maintainer: [YodaDistro](https://github.com/YodaDistro)
      8 * Hardware Supported: Raspberry Pi Pico (2040)
      9 * Hardware Availability: 3D Printed Design (https://github.com/YodaDistro/MacroPad)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make handwired/yodadistro/macro:default
     14     
     15 Flashing example for this keyboard:
     16 
     17     make handwired/yodadistro/macro:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs)
     20 
     21 ## Bootloader
     22 
     23 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     24 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     25 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available