qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1434B)

      1 # Sweeq
      2 
      3 ![sweeq](https://i.imgur.com/TGSyHHxh.png)
      4 
      5 *Sweeq is a Ferris Sweep clone that uses diodes, instead of the latter's direct pin matrix.*
      6 
      7 The primary goal is to free up the SDA/SCL pins so they can be used by auxiliary devices such as a trackball, trackpoint or an OLED screen.
      8 
      9 Other than the diode changes and the ability to use hotswap sockets, this keyboard is identical to the original Sweep.
     10 
     11 * Keyboard Maintainer: [@idank](https://github.com/idank)
     12 * Hardware Supported: [sweeq](https://github.com/idank/keyboards/tree/main/sweeq)
     13 * Hardware Availability: *[holykeebs](https://holykeebs.com)*
     14 
     15 Make example for this keyboard (after setting up your build environment):
     16 
     17     make idank/sweeq:default
     18 
     19 Flashing example for this keyboard:
     20 
     21     make idank/sweeq:default:flash
     22 
     23 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     24 
     25 ## Bootloader
     26 
     27 Enter the bootloader in 3 ways:
     28 
     29 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     30 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     31 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available