qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1220B)

      1 # Velvet Solder PCB by Maker Keyboards
      2 
      3 ![Velvet Solder PCB](https://imgur.com/4lMWY6Dh.jpg)
      4 
      5 The following is the QMK Firmware for the Velvet Solder PCB by [Maker Keyboards](http://www.makerkeyboards.com).
      6 * Keyboard Maintainer: Maker Keyboards
      7 * Hardware Supported: Velvet
      8 
      9 Make example for this keyboard (after setting up your build environment):
     10 
     11     make lucid/velvet_solder:default
     12 
     13 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     14 
     15 ## Bootloader
     16 
     17 Enter the bootloader in 2 ways:
     18 
     19 * **Bootmagic reset**: Hold down the top left key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     20 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available (Fn+Backslash by default)
     21 
     22 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).