qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1160B)

      1 # macrocat
      2 
      3 ![macrocat](https://i.imgur.com/ItLHGBfh.jpg)
      4 
      5 A cat like macro keyboard/numpad.
      6 
      7 * Keyboard Maintainer: [catmunch](https://github.com/catmunch), [starcatmeow](https://github.com/starcatmeow)
      8 * Hardware Supported: Fully Supported
      9 * Hardware Availability: [MacroCat Keyboard](https://github.com/catmunch/macrocat)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make macrocat:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make macrocat:default:flash
     18 
     19 ## Bootloader
     20 
     21 Enter the bootloader in 3 ways:
     22 
     23 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     24 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     25 * **Brand new atmega32u4 chip**: Plug the cable in, it will automatically boot into bootloader
     26 
     27 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).