qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1190B)

      1 # Oreum
      2 
      3 ![Oreum](https://i.imgur.com/Dxc1y0Ol.png)
      4 
      5 A PCB for Oreum Keyboard, base on ZED1800 PCB
      6 
      7 * Keyboard Maintainer: [mechlovin](https://github.com/mechlovin)
      8 * Hardware Supported: The Oreum Keyboard, APM32F103
      9 * Hardware Availability: [Reddit GB](https://www.reddit.com/r/MechanicalKeyboards/comments/xjqddx/gb_oreum_cp_gb_has_started/)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make mechlovin/zed1800/oreum:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make mechlovin/zed1800/oreum:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     27 * **Keycode in layout**: Press the key mapped to `RESET` if it is available