qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1177B)

      1 # zed60
      2 
      3 ![zed60](https://i.imgur.com/KyTpfmMl.png)
      4 
      5 Zed60 PCB, 60% keyboard PCB.
      6 * Keyboard Maintainer: [Mechlovin'](https://mechlovin.studio)
      7 * Hardware Supported: Zed60, APM32F103
      8 * Hardware Availability: [Mechlovin'](https://mechlovin.studio)
      9 
     10 Make example for this keyboard (after setting up your build environment):
     11 
     12     make mechlovin/zed60:default
     13 
     14 Flashing example for this keyboard:
     15 
     16     make mechlovin/zed60:default:flash
     17 
     18 ## Bootloader
     19 
     20 Enter the bootloader in 4 ways:
     21 
     22 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     23 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     24 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available
     25 * **Bootloader**: Hold down the key at (0,13) in the matrix (Backspace) and plug in the keyboard 
     26 
     27 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).