qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1246B)

      1 # zed65
      2 
      3 ![Zed65](https://i.imgur.com/IbsSLb6h.jpeg)
      4 
      5 A 65% PCB with centered USB and JST-SH support, using APM32F103.
      6 
      7 * Keyboard Maintainer: [Mechlovin](https://github.com/mechlovin)
      8 * Hardware Supported: Ori, No2//65, Iron165...
      9 * Hardware Availability: [Mechlovin' Studio](https://mechlovin.studio/)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make mechlovin/zed65/rev1
     14 
     15 Flashing example for this keyboard:
     16 
     17     make mechlovin/zed65/rev1:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 4 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Bootloader reset**: Hold down the key at (0,13) in the matrix (usually the Back Space) and plug in the keyboard
     27 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     28 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available