qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1225B)

      1 # lilith
      2 
      3 ![lilith](https://i.imgur.com/aHr3Iiah.jpg)
      4 
      5 Lilith by nix studio. 65% keyboard with gasket mount
      6 
      7 * Keyboard Maintainer: [Martin Arnstad](https://github.com/arnstadm)
      8 * Hardware Supported: Lilith PCB
      9 * Hardware Availability: https://www.antipode.no/products/nix-lilith
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     qmk compile nix_studio/lilith -km default
     14 
     15 Flashing example for this keyboard:
     16 
     17     qmk flash nix_studio/lilith -km default
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the top left key and plug in the keyboard. This will also clear emulated EEPROM, so it is a good first step if the keyboard is misbehaving.
     26 * **Physical reset button**: Briefly press the button on the back of the PCB, located on the top right
     27 * **Keycode in layout**: There is no key mapped to `QK_BOOT` in the pre-created keymaps, but you may assign this key in any keymaps you create.