qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1215B)

      1 # Albacore
      2 
      3 A small 7-key macropad featuring hotswap and per-key RGB
      4 
      5 ![Albacore](https://i.imgur.com/BTPHnuQh.jpg)
      6 
      7 * Keyboard Maintainer: paprikman
      8 * Hardware Supported: Albacore hotswap pcb
      9 * Hardware Availability: Private group buy
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make paprikman/albacore:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make paprikman/albacore:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 There are several ways to enter the bootloader:
     24 * **Using keycode**: Press the `QK_BOOT` key (if mapped)
     25 * **Bootmagic reset**: Hold the left bottom key (default mod key) and plug the usb cable
     26 * **Physical reset**: In the top right corner of the bottom part of the pcb you will find two pads. Shorten them with tweezers and plug the usb cable, then release. It is also possible to shorten these pads while the macropad is already connected (shorten and hold for a couple of seconds, then release).