qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1146B)

      1 # mino
      2 
      3 ![Mino](https://i.imgur.com/f5kHu8Qh.jpg)
      4 
      5 A 47 key board with a retro twist.
      6 
      7 * Keyboard Maintainer: [ShandonCodes](https://github.com/ShandonCodes)
      8 * Hardware Supported: Mino PCB
      9 * Hardware Availability: Groupbuy
     10 
     11 ## Bootloader
     12 
     13 Enter the bootloader in 3 ways:
     14 
     15 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     16 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     17 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available. For the default keymap it is the middle spacebar on the second layer.
     18 
     19 Make example for this keyboard (after setting up your build environment):
     20 
     21     make shandoncodes/mino/hotswap:default
     22 
     23 Flashing example for this keyboard:
     24 
     25     make shandoncodes/mino/hotswap:default:flash
     26 
     27 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).