qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1468B)

      1 # Sleepy Keeb
      2 
      3 ![sleepy_keeb](https://i.imgur.com/y3cessF.jpeg)
      4 
      5 The Sleepy Keeb is a hand-wired keyboard based on the 4x12 Planck layout. The Sleepy Keeb integrates hot-swap socket and diode holders into the plate for easier building.
      6 
      7 - Keyboard Maintainer: [Sleepy Craft Studios](https://github.com/sleepy-craft-studios)
      8 - Hardware Supported: Pro Micro development board (and clones/adapations of)
      9 - Hardware Availability: [Sleepy Craft Studios Shop](https://sleepycraftstudios.com/shop) for kits and full builds, [Sleepy Craft Studios Downloads](https://sleepycraftstudios.com/downloads) for CC-BY-SA-NC licensed stl files for 3D printing.
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make sleepy_keeb:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make sleepy_keeb:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 - **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 - **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     27 - **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available