readme.md (1989B)
1 # snes_macropad 2 3  4 *Completed Build* 5 6  7 *Completed Build, closer with RGB off* 8 9  10 *PCB and FR4 top/bottom plates* 11 12 The SNES Macropad is, as it sounds, a macropad that features a SNES connector. In addition it has a qwiic connector and a 3.5mm jack for 3.3V I2C (not audio), allowing additional expansion. 13 14 This QMK implementation exposes the SNES controller as a part of the keyboard, meaning you can map the controller to do anything a qmk keyboard can. The layout is thus a 4x6 keyboard logically, split with the 3 first rows being on the macro pad and the 3 following being buttons on the snes controller. 15 16 * Keyboard Maintainer: [JBarberU](https://github.com/jbarberu) 17 * Hardware Supported: SNES Macropad Rev 1, with a Raspberry Pi Pico Lite (AliExpress clone of Raspberry Pico with fewer grounds and all GPIO's exposed on the headers) 18 * Hardware Availability: The SNES Macro pad can be found [here](https://www.tindie.com/products/jbarberu/snes-macropad/) either as a kit, partially built or fully built. 19 20 Make example for this keyboard (after setting up your build environment): 21 22 make snes_macropad:default 23 24 Flashing example for this keyboard: 25 26 make snes_macropad:default:flash 27 28 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). 29 30 ## Bootloader 31 32 Enter the bootloader in 3 ways: 33 34 * **Physical bootsel button**: Hold down the bootsel button on the RPi Pico while plugging in the keyboard, or while pressing the reset button 35 * **Physical reset button**: Quickly double press the reset button 36 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available