qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1157B)

      1 # stardustn0
      2 
      3 ![stardustn0](https://i.imgur.com/9SWMHH4.jpeg)
      4 
      5 This project is a custom-built split ergonomic mechanical keyboard, using two Raspberry Pi Pico microcontrollers.
      6 
      7 * Keyboard Maintainer: [navidyt](https://github.com/navidyt)
      8 * Hardware Supported: Raspberry Pi Pico, MX switches, Gateron hot-swap sockets, 1N4148 diodes, generic USB-C breakout board
      9 
     10 Make example for this keyboard (after setting up your build environment):
     11 
     12     make stardustn0:default
     13 
     14 Flashing example for this keyboard:
     15 
     16     make stardustn0:default:flash
     17 
     18 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     19 
     20 ## Bootloader
     21 
     22 Enter the bootloader in 3 ways:
     23 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     24 * **Physical reset button**: Briefly press the  reset button on the pico while connecting USB
     25 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available