qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1397B)

      1 # studiokestra/galatea
      2 
      3 ![studiokestra/galatea](https://i.imgur.com/juPhV1xh.png)
      4 
      5 TKL H87/88c compatible PCB with support for the most common layouts.
      6 
      7 * Keyboard Maintainer: [Studio Kestra](https://github.com/studiokestra/)
      8 * Hardware Supported: Most H87C compatible keyboards
      9 * Hardware Availability: https://RNDKBD.com; https://geon.works/
     10 * Rev1 firmware is used for Galatea PCBs with no RGB underglow.
     11 * Rev2 firmware is used for Galatea PCBs with RGB underglow.
     12 * Rev3 firmware is used for Galatea PCBs with RP2040 chip w/ RGB underglow.
     13 
     14 Make example for this keyboard (after setting up your build environment):
     15 
     16     make studiokestra/galatea/rev1:default
     17 
     18 Flashing example for this keyboard:
     19 
     20     make studiokestra/galatea/rev1:default:flash
     21 
     22 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     23 
     24 ## Bootloader
     25 
     26 Enter the bootloader in 3 ways:
     27 
     28 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     29 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     30 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available