qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1360B)

      1 # grandiceps
      2 
      3 ![grandiceps](https://i.imgur.com/FMtsboVl.jpg)
      4 
      5 ARM split keyboard with RGB underglow and encoders.
      6 
      7 * Keyboard Maintainer: [vattern](https://github.com/vattern)
      8 * Hardware Supported: f411 blackpill
      9 * Hardware Availability: [grandiceps](https://github.com/vattern/grandiceps)
     10 
     11 There are two versions of the Grandiceps. Please use the appropriate firmware for your board.
     12 
     13 * Revision 2 has I2C eeprom and support for a Pimoroni trackball.
     14 
     15 Make example for this keyboard (after setting up your build environment):
     16 
     17     make tkw/grandiceps:default
     18     make tkw/grandiceps/rev2:default
     19 
     20 Flashing example for this keyboard:
     21 
     22     make tkw/grandiceps:default:flash
     23     make tkw/grandiceps/rev2:default:flash
     24 
     25 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     26 
     27 ## Bootloader
     28 
     29 Enter the bootloader in 3 ways:
     30 
     31 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     32 * **Physical reset buttons**: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
     33 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available