qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1116B)

      1 # pad
      2 
      3 ![pad](https://i.imgur.com/KMS1btN.jpeg)
      4 
      5 A simple 5-Key Macropad based off an RP2040 and custom PCB.
      6 
      7 * Keyboard Maintainer: [Jon Henry](https://github.com/togkey86)
      8 * Hardware Supported: TogKey Pad PCB, RP2040 Pro Micro Development Board
      9 * Hardware Availability: (https://togkey.com)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13      make togkey/pad:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make togkey/pad:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     27 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available