qmk_firmware

QMK firmware for my keyboards (Corne, Sweep Ferris) and trackball (Ploopy Adept)
Log | Files | Refs | Submodules | LICENSE

readme.md (1312B)

      1 # E8ghty
      2 
      3 ![trnthsn/e8ghty](https://imgur.com/M4Oudco.png)
      4 
      5 A TKL keyboard PCB compatible with various keyboard cases. Supports both right USB Type-C connector and bottom USB Type-C connector, 1 FPC header, and 3 JST SH positions for a daughter board.
      6 
      7 * Keyboard Maintainer: [ThanhSon.Mech](https://github.com/trnthsn)
      8 * Hardware Supported: STM32F103/STM32F072, Geon F1 xx, TKD Cycle 8, Keycult, ...
      9 * Hardware Availability: [ThanhSon.Mech](https://www.facebook.com/ThanhSon.mech)
     10 
     11 Make example for this keyboard (after setting up your build environment):
     12 
     13     make trnthsn/e8ghty:default
     14 
     15 Flashing example for this keyboard:
     16 
     17     make trnthsn/e8ghty:default:flash
     18 
     19 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
     20 
     21 ## Bootloader
     22 
     23 Enter the bootloader in 3 ways:
     24 
     25 * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
     26 * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
     27 * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available