readme.md (1694B)
1 # Model-B 2 3 A 75% keyboard based on the RP2040. 4 5 * Keyboard Maintainer: [Brian Hill](https://github.com/TrojanPinata) 6 * Hardware Supported: [GitHub](https://github.com/TrojanPinata/Model-B) 7 8 ## Revisions 9 10 At the current moment there is only one variant of the Model-B, the rev-0 (aka the prototype board). Any others are clones and may not have the exact firmware requirements. 11 12 ## Building and Flashing 13 14 Make example for this keyboard (after setting up your build environment): 15 16 make trojan_pinata/model-b/rev0:default 17 18 Flashing example for this keyboard: 19 20 make trojan_pinata/model-b/rev0:default:flash 21 22 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). 23 24 ## Bootloader 25 26 Enter the bootloader in 3 ways: 27 28 * **Bootmagic reset**: Hold down the top left key and plug in the keyboard. This will also clear the emulated EEPROM, so it is a good first step if the keyboard is misbehaving. 29 * **Physical reset button**: Hold down the `BOOTSEL` button on the Pi Pico, then either plug the board in or press the `RESET` button. 30 * **Keycode in layout**: Press the key mapped to `QK_BOOT`. In the pre-supplied keymaps it is on the second layer, replacing the Esc key. 31 32 After entering the bootloader through one of the three methods above, the keyboard will appear as a USB mass storage device named `RPI-RP2`. If the CLI is unable to find this device, the compiled `.uf2` file can be manually copied to it. The keyboard will reboot on completion with the new firmware loaded.